Table of Contents
Advertisement
Suffixes
The Suffix character(s) is/are user-definable data characters that can be sent after the scanned
data. To enable or disable suffixes, scan the appropriate code below. Default = Disabled.
Enable Suffixes
* Disable Suffixes
To set the suffix parameters to their default values, use the following code:
Suffix Block String
Use the command SUFBLOK in combination with one or more sets of two hexadecimal digits to
define a specific ASCII character (or set of characters) as Suffix or by scanning the barcode
below and then set the ASCII character by scanning the digit codes and the SAVE barcode in
Appendix B
. Please contact JADAK if assistance is needed.
Appendix D
Look at the ASCII conversion chart in
to see what hex digits convert to specific
ASCII characters.
For example; SUFBLOK 410A results in adding an A and a Line Feed (LF) behind each scanned
barcode. Default Setting (Carriage Return (hex: 0D) as Suffix):
Suffix Clear
To clear all suffixes, use the following code:
JADAK FM-8/FM-9 User's Manual
Advertisement
Table of Contents
