Code 39; Code 39 Defaults; Code 39 On/Off; Code 39 Minimum And Maximum Length - Novanta JADAK FM-8 User Manual

Code 39

Code 39 Defaults

Code 39 On/Off

Scan one of the codes below to enable or disable Code 39. Default = Enabled.
* Enable

Code 39 Minimum and Maximum Length

Use the following commands in combination with numerical values to set the minimum
and maximum length for allowed Code 39 barcodes.
Default minimum length = 0. Default maximum length = 48.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 0 and 48, or by
scanning one of the barcodes below and then set the length by scanning the digit codes
and the SAVE barcode in
Code 39 Minimum length

Code 39 Full ASCII Conversion

Code 39 Full ASCII is a variant of Code 39 that pairs certain characters so it can include
the entire ASCII set. Default = Disabled.
Enable
JADAK FM-8/FM-9 User's Manual
Appendix B
. Please contact JADAK if assistance is needed.
Disable
Code 39 Maximum length
* Disable