Aimer Delay - Novanta JADAK FM-8 User Manual

Aimer Delay

The FM-8/FM-9's aimer allows a delay time for the user to aim the engine before actual
scanning begins. During this delay, the aiming light will appear, but the scanner's illumination
won't show, until the delay time has passed. During this delay, barcodes cannot be scanned.
This command sets the Aimer Delay Time in steps of 1 millisecond from 1ms up to 4000ms
(4 seconds). Default = Off.
Several commonly used Aimer Delay menu command barcodes are included below.
If a different delay time other than those provided is needed, it can be set either by sending
the serial command AIM_DLY x (where 'x' is a value between 0 and 4000), or by
scanning the top barcode below and then set the time by scanning the digit codes and
the SAVE barcode in
Sample settings:
* Aimer Delay Off
Aimer Delay = 1000ms
Aimer Delay = 2000ms
JADAK FM-8/FM-9 User's Manual
Appendix B . Please contact JADAK if assistance is needed.
Aimer Delay = 500ms
Aimer Delay = 1500ms
Aimer Delay = 4000ms