Composite Code; Gs 1 Composite Code On/Off; Composite Code Minimum And Maximum Length - Novanta JADAK FM-8 User Manual

Composite Code

GS 1 Composite Code On/Off

Linear codes are combined with a unique 2D composite component to form a new class
called GS1 Composite symbology. GS1 Composite symbologies allow for the co-
existence of symbologies already in use.
Scan one of the codes below to enable or disable Composite Code. Default = Disabled.
Enable

Composite Code Minimum and Maximum Length

Use the following commands in combination with numerical values to set the minimum
and maximum length for allowed Composite Code barcodes.
Default minimum length = 1. Default maximum length = 2435.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 1 and 2435, or
by scanning one of the barcodes below and then set the length by scanning the digit
codes and the SAVE barcode in
Please contact JADAK if assistance is needed.
Composite Code Minimum length
JADAK FM-8/FM-9 User's Manual
Appendix B
.
* Disable
Composite Code Maximum length