Micropdf417; Micropdf417 Defaults; Micropdf417 On/Off; Micropdf417 Minimum And Maximum Length - Novanta JADAK FM-8 User Manual

MicroPDF417

MicroPDF417 Defaults

To set the default values for Micro PDF417, scan this code:

MicroPDF417 On/Off

Scan one of the codes below to enable or disable Micro PDF417. Default = Disabled.
Enable

MicroPDF417 Minimum and Maximum Length

Use the following commands in combination with numerical values to set the minimum
and maximum length for allowed MicroPDF417 barcodes.
Default minimum length = 1. Default maximum length = 366.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 1 and 366, or
by scanning one of the barcodes below and then set the length by scanning the digit
codes and the SAVE barcode in
Please contact JADAK if assistance is needed.
MicroPDF Minimum length
JADAK FM-8/FM-9 User's Manual
Appendix B .
* Disable
MicroPDF Maximum length