Code 128
Code 128 Defaults
Code 128 On/Off
Scan one of the codes below to enable or disable Code 128 decoding. Default = Enabled.
* Enable
Code 128 Minimum and Maximum Length
Use the following commands in combination with numerical values to set the minimum
and maximum length. Default minimum length = 0. Default maximum length = 55.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 0 and 55, or by
scanning one of the barcodes below and then set the length by scanning the digit codes
and the SAVE barcode in
Code 128 Minimum length
ISBT 128 On/Off
ISBT 128 is a variant of Code 128 used in the blood bank industry. Scan the appropriate
bar code below to enable or disable ISBT 128 concatenation. Default = Disabled.
Enable
JADAK FM-8/FM-9 User's Manual
Appendix B
. Please contact JADAK if assistance is needed.
Disable
Code 128 Maximum length
* Disable