Maxi Code
Maxi Code Defaults
To set the default values for Maxi Code, scan this code:
Maxi Code On/Off
Scan one of the codes below to enable or disable Maxi Code. Default = Disabled.
Enable
Minimum and Maximum Length
Maxi Code
Use the following commands in combination with numerical values to set the minimum
and maximum length for allowed Maxi Code barcodes.
Default minimum length = 1. Default maximum length = 150.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 1 and 150, or
by scanning one of the barcodes below and then set the length by scanning the digit
codes and the SAVE barcode in
Please contact JADAK if assistance is needed.
Maxi Code Minimum length
JADAK FM-8/FM-9 User's Manual
Appendix B
.
* Disable
Maxi Code Maximum length