Code 11; Code 11 Defaults; Code 11 On/Off; Code 11 Minimum And Maximum Length - Novanta JADAK FM-8 User Manual

Table of Contents

Advertisement

Code 11

Code 11 Defaults

Set all Code 11 settings to their default configuration with this code/command.

Code 11 On/Off

Scan one of the codes below to enable or disable Code 11. Default = Disabled.
Enable

Code 11 Minimum and Maximum Length

Use the following commands in combination with numerical values to set the minimum
and maximum length for allowed Code 11 barcodes.
Default minimum length = 4. Default maximum length = 55.
The minimum and maximum length for this symbology can be set either by sending the
serial command shown under the barcodes below with a value between 1 and 55, or by
scanning one of the barcodes below and then set the length by scanning the digit codes
and the SAVE barcode in
Please contact JADAK if assistance is needed.
Code 11 Minimum length
JADAK FM-8/FM-9 User's Manual
Appendix B
.
* Disable
Code 11 Maximum length

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jadak fm-9

Table of Contents