UPC-A
UPC-A Defaults
Set the UPC-A settings to their default configuration with this command.
UPC-A On/Off
Scan one of the codes below to enable or disable UPC-A. Default = Enabled.
* Enable
UPC-A Check Digit
The check digit is the last character and is used to verify data integrity. This digit is always
checked but it may be chosen whether or not to transmit it. Default=Transmit Check Digit.
* Transmit UPC-A Check
UPC-E1
Scan one of the codes below to enable or disable UPC-E(1). Default = Disabled.
Enable
JADAK FM-8/FM-9 User's Manual
Disable
Do Not Transmit UPC-A Check
* Disable