Good Read Delay - Novanta JADAK FM-8 User Manual

Good Read Delay

This sets the time period before the FM-8/FM-9 can read another bar code.
Several commonly used good read delay menu command barcodes are included below.
Default time = 0 Seconds.
Note: Good Read Delay is most effective when in Presentation Mode or when Multiple Symbol
Mode is turned on in combination with another Trigger Mode.
Setting examples:
* No Good Read delay
Good Read delay 0.5 seconds
Good Read delay 2.0 seconds
If a different delay time other than those provided is needed, it can either be set by sending the
serial command DLYGDRD x (where 'x' is a value between 0 and 30000), to set the time
between 0 (no delay) and 30000 (=30 sec.) in steps of 1 millisecond, or by scanning the barcode
below, then set the delay by scanning the digit codes and the SAVE barcode in
Please contact JADAK if assistance is needed.
JADAK FM-8/FM-9 User's Manual
User Specified Good-read Delay
Good Read delay 0.2 seconds
Good Read delay 1.0 seconds
Good Read delay 5.0 seconds
Appendix B .