Renesas M3028BT2-CPE User Manual page 83

M3028BT2-CPE User's Manual
Notes on Debugging in CPU Rewrite Mode:
When you debug M16C/Tiny Series MCUs in CPU rewrite mode, do not change the block 0 area (FF000h--
FFFFFh) of the flash ROM. Otherwise, the emulator will be uncontrollable.
If you check "Debug the program using CPU Rewrite Mode" in the MCU tab of the Init dialog box of the
emulator debugger, you cannot use the following functions.
(1) Setting software breakpoints in an internal ROM area
(2) Executing COME in an internal ROM area
Do not stop the program in CPU rewrite mode or erase suspend mode. And do not single-step the instructions
shifting to the CPU rewrite mode or erase suspend mode. The emulator will go out of control in CPU rewrite
mode or erase suspend mode.
Do not stop the program in CPU rewrite mode. And do not single-step the instructions shifting to the CPU
rewrite mode. The emulator will go out of control in CPU rewrite mode.
As the following interrupt vectors are used by the emulator system, the read data is different from expected
value.
(1) BRK instruction (FFFE4h--FFFE7h)
(2) Address match (FFFE8h--FFFEBh)
(3) Single-step (FFFECh--FFFEFh)
(4) DBC (FFFF4h--FFFF7h)
Notes on CE Declaration of Conformity:
Please use this product with care as described below.
* Electrostatic Discharge Precautions must be taken when handling the product.
* Must not be used within 30 meters of a domestic radio or television receiver.
* For correct operation of this product, it is recommended that Mobile phones are not used within 10 meters of
this product system.
* This product should be powered down when not in use.
* Use the power supply which complies with CE marking requirements.
This product generates, uses, and can radiate radio frequency energy and may cause harmful interference to
radio communications.
If this product causes harmful interference to radio or television reception, which can be determined by turning
this product off or on, you are encouraged to try to correct the interference by one or more of the following
methods;
* Ensure attached cables do not lie across the probe board and converter board.
* Reorient the receiving antenna.
* Increase the distance between the product and the receiver.
* Connect the product into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or experienced radio/TV technician for help.
Attach the ferrite core included with this product close to the DC plug of the power cable. Without the ferrite
core it may cause interference.
The power cable should be wound around the ferrite core as shown in the figure, and close the ferrite core until
it clicks.
REJ10J1457-0300 Rev.3.00 July 22, 2009
IMPORTANT
4. Hardware Specifications
Page 81 of 90