Renesas M3028BT2-CPE User Manual page 30

M3028BT2-CPE User's Manual
When the user system connected:
If the POWER LED does not light,
shut off the system and check the
setting of the jumper switches and
check if the power is properly
supplied to the user system.
Figure 2.9 Target status LEDs display when the emulator starts up normally (when user system connected)
Note on the Target Status CLOCK LED:
If the LED is not turned on, check the following.
- After the emulator debugger is started up (after the Init dialog box settings are completed):
Make sure that the oscillator selected in the Init dialog box is oscillating normally.
REJ10J1457-0300 Rev.3.00 July 22, 2009
POWER
CLOCK
RESET
: ON
RUN
: OFF
After turning the power ON.
IMPORTANT
POWER
LED 3
CLOCK
LED4
RESET
LED5
RUN
LED6
After starting up the emulator debugger.
2. Setup
LED 3
LED4
LED5
LED6
Page 28 of 90