Table of Contents
Advertisement
M3028BT2-CPE User's Manual
1.3 Specifications
Table 1.5 lists specifications of the M3028BT2-CPE.
Table 1.5 M3028BT2-CPE specifications
Applicable MCUs
Evaluation MCU
Usable mode
Maximum operating frequency
Applicable power supply
Basic debugging functions
Real-time trace function
Real-time RAM monitor function
Hardware break function
Execution time measurement function
Connection to user system
(see "2.8 Connecting the User System"
on page 31)
Power supply for emulator
Host machine interface
*1 The hardware break function and trace point settings of the realtime trace function cannot be used at the same time.
*2 Available to connect the host machine that supports USB 2.0. With the USB interface, not all hardware (such as host
machine, USB devices, USB hub) combination will work and guaranteed.
REJ10J1457-0300 Rev.3.00 July 22, 2009
M16C/Tiny Series
M30290FCWP
ROM size: 128KB + 4KB, RAM size: 12KB
Single-chip mode
Power voltage at 4.2 to 5.5V: 24MHz (for 24MHz: when using PLL)
Power voltage at 3.0 to 5.5V: 20MHz
Power voltage at 2.7 to 5.5V: 10MHz
User system connected
(JP1=EXT)
User system not connected
(JP1=INT)
- Download
- Software break (max. 64 points)
- Program execution/stop (allows free-run execution supporting software breaks)
- Memory reference/setting (reference/setting C-variables, run-time execution)
- Register reference/setting
- Disassemble display
- C-level debugging, etc.
- 64K-cycle bus information recordable
(20-bit address, 16-bit data, 12-bit MCU status)
- 5 trace modes supported (Break/Before/About/After/Full)
- Can be recorded ON/OFF by events
- 1,024 bytes (256 bytes x4)
- Data/last access result
2 points (Address match, bus match, max. 255 pass counts)
Time between program start and stop
For 42-pin 0.8mm pitch SSOP (PRSP0042GA-B , Previous code: 42P2R-E)
M30263T-42SSB (included with the M3028BT2-CPE-1)
For 48-pin 0.5mm pitch LQFP (PLQP0048KB-A, Previous code: 48P6Q-A):
M30260T-48FPD (included with the M3028BT2-CPE-2)
For 64-pin 0.5mm pitch LQFP (PLQP0064KB-A, Previous code: 64P6Q-A):
M30291T-64FPD (included with the M3028BT2-CPE-3)
For 80-pin 0.5mm pitch LQFP (PLQP0080KB-A, Previous code: 80P6Q-A):
M30290T-80FPD (included with the M3028BT2-CPE-4)
For 85-pin 0.65mm pitch TFLGA (PTLG0085JB-A, Previous code: 85F0G):
M30280T-85LGF (included with the M3028BT2-CPE-5)
DC 5.0V ±5 %/(2A) externally supplied (Prepare a power supply which complies
with CE marking requirements separately.)
*2
USB (USB 1.1 full-speed
2.7 to 5.5V
3.3 V or 5.0V
(supplied from the emulator, set by JP2)
, mini-B standard connector)
1. Outline
*1
Page 19 of 90
Advertisement
Table of Contents
