Names And Functions Of Each Part Of The Emulator - Renesas M3028BT2-CPE User Manual

M3028BT2-CPE User's Manual
(5) Power supply for the user system
This is a power supply for the user system. As this emulator cannot supply the power to the user system, supply the power
to the user system separately from the emulator.
(6) Host machine
This is a personal computer for controlling the emulator.
(7) Package converter board such as M30290T-80FPD
This is a package converter board for connecting to an MCU foot pattern on the user system. For details, refer to "2.8
Connecting the User System" (page 31).

1.2.2 Names and Functions of each part of the Emulator

Figure 1.2 shows the names of the LEDs on the upper panel of the emulator.
System status LEDs
LED1: Emulator power (POWER)
LED2: Emulator startup (SAFE)
Target status LEDs
LED3: User system power (POWER)
LED4: Clock oscillation (CLOCK)
LED5: MCU RESET (RESET)
LED6: Program execution (RUN)
Figure 1.2 Names of the LEDs on the upper panel of the M3028BT2-CPE
(1) System Status LEDs
The system status LEDs indicate the emulator main unit's operating status etc. Table 1.2 lists the definition of the system status
LEDs.
Table 1.2 Definitions of the system status LEDs
Name Number Color
POWER LED1 Orange
SAFE LED2 Green
REJ10J1457-0300 Rev.3.00 July 22, 2009
POWER
LED1 SYSTEM
POWER
SAFE
STATUS
SAFE
LED2
COMPACT EMULATOR
M3028BT2-CPE
LED3
POWER
POWER
CLOCK
CLOCK
TARGET
RESET
RESET
RUN STATUS
RUN
LED6
COMPACT EMULATOR
MADE IN JAPAN
Status
ON Power is supplied to the emulator.
OFF Power is not supplied to the emulator.
ON Emulator system has started normally.
OFF Emulator system has not started normally.
J1: Power connector
POWER USB
5.0V
SW1
5.0V
JP2
3.3V
EXT
JP1
INT
MADE
Meaning
J2: USB interface connector
System reset switch
JP2: MCU power supply voltage selection jumper
(factory-setting: 5.0V)
JP1: MCU power supply source selection jumper
(factory-setting: INT)
Page 16 of 90
1. Outline