Led Display When The Emulator Starts Up Normally - Renesas M3028BT2-CPE User Manual

M3028BT2-CPE User's Manual

2.6.5 LED Display When the Emulator Starts Up Normally

After the emulator starts up, check the status of the LEDs to see whether the emulator operation is enabled or not. Figure 2.7
shows the positions of the emulator status LEDs.
System status LEDs
Target status LEDs
Figure 2.7 Positions of the system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 and LED2 of the system status LEDs are lit immediately after the power is activated. If it is not lit, shut
off the emulator and check the power supply for the emulator is properly connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.8 when the user system is not connected and as shown in Figure 2.9 when a user
system is connected.
When the target status LEDs do not display as shown in Figures 2.8 and 2.9, refer to "5. Troubleshooting" (page 82).
When the user system NOT connected:
The POWER LED does not light.
Figure 2.8 Target status LEDs display when the emulator starts up normally (when user system not connected)
REJ10J1457-0300 Rev.3.00 July 22, 2009
POWER
LED1
POWER
SAFE
SAFE
LED2
LED3
POWER
POWER
CLOCK
CLOCK
RESET
RESET
RUN
RUN
LED6
COMPACT EMULATOR
POWER
CLOCK
RESET
: ON
: OFF
RUN
After turning the power ON.
POWER USB
5.0V
SYSTEM
J2
STATUS
J1
COMPACT EMULATOR
M3028BT2-CPE
TARGET
STATUS
MADE
MADE IN JAPAN
LED3 POWER
CLOCK
LED4
RESET
LED5
LED6 RUN
After starting up the emulator debugger.
2. Setup
SW1
5.0V
JP2
3.3V
EXT
JP1
INT
LED3
LED4
LED5
LED6
Page 27 of 90