Renesas M3028BT2-CPE User Manual page 19

M3028BT2-CPE User's Manual
(2) Target Status LEDs
The target status LEDs indicate the target MCU's power supply and operating status.
Table 1.3 lists the definition of each target status LED.
Table 1.3 Definitions of the target status LEDs
Name Number Color
POWER LED3 Orange
CLOCK LED4 Green
RESET LED5
RUN LED6 Green
(3) System Reset Switch
By pressing the system reset switch, you can initialize the emulator system.
Table 1.4 shows the functions of the system reset switch depending on the state of the emulator.
Table 1.4 Functions of the system reset switch
State of Emulator
When the user's program is halted
When the user's program is executed
Notes on a System Reset:
After pressing the system reset switch, restart the emulator debugger. Otherwise the display of emulator
debugger and the actual value (in the emulator) may not match.
When the emulator debugger does not start up normally even after rebooting, turn off the emulator and then turn
on again.
(4) Power Connector (J1)
This is a connector for connecting the power supply to this product. For details, refer to "2.4 Connecting the Power Supply for
the Emulator" (page 23).
(5) USB Cable Connector (J2)
This is a USB cable connector for connecting the host machine to this product. For details, "2.5 Connecting the Host Machine"
(page 24).
REJ10J1457-0300 Rev.3.00 July 22, 2009
Status
ON Power is supplied to the target MCU.
OFF Power is not supplied to the target MCU.
ON The target MCU internal clock is oscillating.
OFF The target MCU internal clock is not oscillating.
Red ON Target MCU is being reset, or reset signal of the user system is held low.
OFF Target MCU is not being reset.
ON User program is being executed.
OFF User program is not being executed.
Initializes the emulator and waits for a command from the
emulator debugger
Stops the user's program, initializes the emulator, and
waits for a command from the emulator debugger.
IMPORTANT
Meaning
Function
1. Outline
Page 17 of 90