Adjusting Simulation Settings - Xilinx Spartan-6 User Manual

Chapter 1: Spartan-6 FPGA GTP Transceiver Signal Integrity Simulation Kit

Adjusting Simulation Settings

1.
2.
X-Ref Target - Figure 1-6
14
Click Run Interactive Simulation (Oscilloscope) under the Simulate tab.
Select the Eldo/ADMS radio button under the Start Simulation button, as shown in
Figure 1-6.
Figure 1-6: Assign Probes, Select Eldo as Simulation Engine, and
www.xilinx.com
Select and Configure Stimulus
Select Eldo Simulation Engine
Ignore
Select Nodes to be Plotted
Spartan-6 FPGA Equalizer Outputs
Specify Stimulus Type
Spartan-6 FPGA GTP Transceiver SIS Kit (HyperLynx)
UG396_c1_06_051310
UG396 (v1.0) June 10, 2010