Modifying The Receiver Settings - Xilinx Spartan-6 User Manual

Modifying the Receiver Settings

Repeat the steps in
parameters.
For more information on the driver settings, refer to UG386, Spartan-6 FPGA GTP
Transceivers User Guide.
Notes relevant to this section:
X-Ref Target - Figure 1-5
Spartan-6 FPGA GTP Transceiver SIS Kit (HyperLynx)
UG396 (v1.0) June 10, 2010
Modifying the Driver
• The global simulation temperature setting can be changed in either driver or
receiver configurators (see
Eldo, the last change made is applied to the entire circuit, regardless of whether
the TX or RX configurator is used to make that change.
• Be sure to click only once. If multiple instances of the configurators are open, close
all but one by clicking their Cancel buttons.
Figure 1-5: Configure Spartan-6 FPGA Receiver
www.xilinx.com
Settings. Adjust the receiver (U2) simulation
Figure 1-5). However, because it is a global setting in
Getting Started
UG396_c1_05_042010
13