Xilinx Spartan-6 User Manual page 20

Appendix A: Frequently Asked Questions
4.
X-Ref Target - Figure A-5
20
What if the simulation does not start or aborts prematurely?
This might occur if:
• The correct simulation in HyperLynx is not selected. Verify that Eldo/ADMS is
the selected simulator engine in the Digital Oscilloscope window.
• The HSPICE compatible radio button is not selected or the Eldo executable is not
listed in the Circuit Simulators tab of the Setup → Options → General dialog
box. See Figure A-5 for proper selection.
• The HyperLynx license is not set to perform Eldo simulations. Contact the license
manager or a Mentor Graphics representative to resolve this issue.
Figure A-5: HSPICE Compatible Radio Button
www.xilinx.com
Spartan-6 FPGA GTP Transceiver SIS Kit (HyperLynx)
UG396 (v1.0) June 10, 2010
UG396_aA_05_042010