Table of Contents
Advertisement
SP-2000/X-Y
MCB Controller Mounting
After the pan/tilt head is mounted, the MCB controller is mounted to a right
angle bar that is attached to the head.
1.
Attach the mounting bracket to the bottom of the head using the four
screws and flat washers provided. Tighten the screws with a 3/16" hex key.
2.
Insert the right angle mounting bar into the bracket and tighten the clamp
screws with a 3/16" hex key. The final positioning of the bar (left/right and
up/down) will depend on the camera position and can be adjusted later.
3.
Mount the MCB controller on the bar and tighten the clamp.
4.
Plug the MCB controller cable into the Local Control Data connector on
the SP-2000 control panel.
User Manual
Mounting Bracket
Installation
Mounting Bar
3-11
Advertisement
Table of Contents
