Mounting The Head - Vinten Vector 70 Maintenance Manual

Contents
3 After unpacking ensure that:
3.1 The centre lock
centre lock before lifting or carrying the head. Lift the head by the base and/or the carrying handle, not
the platform.
3.2 The pan and tilt brakes are on

Mounting the head

NOTE: When mounted on Vinten 'Hawk' or 'Teal' pedestals, clearance between the head and the
pedestal weight tray prevents the use of 5.5 lb (1.6 kg) and 1.0 lb (0.47 kg) trim weights.
Use alternative weights or fit the adaptor plate kit (Part No. 3354-900SP) between the head
and pedestal.
Flat base
WARNING!: Before installing the head, hold a fixing bolt in position and check that the
threaded end does not project more than 12 mm (1/2 in.) above the mounting face.
4 The head is mounted on a tripod, pedestal or suitable firm surface using the four fixing bolts and
washers. Tighten the bolts with the spanner provided.
5 After mounting the head, use the level bubble
pressing the switch (6). The light will go out after approximately 15 seconds.
Mitchell-type fixing
6 Remove the clamp knob and washer. Position the head on the tripod or pedestal, ensuring that the
spigot is seated and the key is engaged in the slot. Refit the clamp washer and knob and tighten securely.
7 After mounting the head, use the level bubble
pressing the switch (6). The light will go out after approximately 15 seconds.
Pan bars
8 Fit the pan bar(s)
the mounting (14). Adjust the length of the telescopic pan bar(s).
(11) is engaged (See "Locking the platform" on page
(See "Pan and tilt brakes" on page
(18) to the head and adjust the position of each one before tightening the clamp on
First
Page
(5) to set it level. The level bubble may be illuminated by
(5) to set it level. The level bubble may be illuminated by
Previous Next
Page Page
16). Always engage the
17).
Previous
View
14