Table of Contents
Advertisement
SP-2000/X-Y
Routine Maintenance
The SP-2000/X-Y is a highly reliable and stable product. Many of the mechani-
cal components are sealed and permanently lubricated. The electronics are well
ventilated and highly rated. The number of connectors is kept to a minimum
and the best quality connectors are utilized. All this adds up to a product that
does not require much general routine maintenance.
However, a few preventive maintenance procedures and routine operational
checks will reduce the likelihood of problems occurring in normal operation.
The procedures are described in detail following the summary chart.
Clean The Targets
Check DC Power
Check Column Balance
Check Overall Operation
Test Emergency Stop Switches
Test Collision Bumper Operation
Clean The Target Sensors
Clean The Slip Rings
Examine The Wheels
Cleaning The Targets
It is very important to keep the targets clean to ensure repeatable targeting. It is
recommended that you clean the targets every day. The top surface of the target
is clear lexan which can be cleaned with any standard household cleaner such as
Fantastic or 409.
Removing Targets
If a target is damaged, or the studio configuration is changed, targets will need
to be replaced. Peel up one corner with a razor blade and try to keep the adhesive
on the back of the target, not on the floor. Slowly pull the target off the floor.
Small areas of adhesive left on the floor can be removed carefully with a razor
blade or by rubbing back and forth with your finger. To move larger areas of
adhesive from the floor before you install the new targets, you can use:
4-6
Topic
•
A 50/50 solution of isopropyl alcohol and water
•
A slightly more aggressive cleaner called "Citrus Based Cleaner"
is available from 3M Company (1-800-524-0399)
Maintenance And Repair
Daily Monthly As Required
X
X
X
X
X
X
(X)
X
X
X
User Manual
Advertisement
Table of Contents
