Table of Contents
Advertisement
SP-2000/X-Y
Calibration
Collision Bumpers
All four detectors are connected to the detector circuit board mounted just below
the cable clamp.
#2
(North Side)
#1
The potentiometer for each of the four collision detectors can be adjusted with-
out removing the cover. Or, you can remove the cover (using a 3/16" hex key)
for greater access. The collision bumpers are numbered 1 through 4 as shown
above and the corresponding pots are numbered 1 through 4 from left to right.
1.
Starting with #1, turn the pot clockwise slowly until the adjacent LED is a
steady red. Turn the pot counterclockwise slowly until the LED is a steady
green.
2.
Press firmly on bumper #1 with your hand or foot. The #1 LED will turn
red as you press on the bumper and back to green when you release. If the
LED tends to flicker when you release the bumper, readjust pot #1.
3.
Repeat these steps for the other three bumpers and pots.
4-24
Calibration Pots
Cover Screws
#4
Maintenance And Repair
#3
User Manual
Advertisement
Table of Contents
