Table of Contents
Advertisement
SP-2000/X-Y
Using The MCB Controller
The MCB controller provides local control at the pedestal, with or without an
ACP-8000P controller connected.
Local/Remote
The MCB must always be in Remote (top switch to the right) when the pedestal
is powered up. In Remote, the controller has control of the pedestal operation.
In Local mode (top switch to the left), the MCB joystick controls the pedestal.
Drive
With the Rotate switch to the right, push the joystick up/down/left/right or any
angle in between to drive the pedestal in the desired direction. Regardless of the
pan angle of the head, up/down on the joystick drives the pedestal in the North
and South direction. Right/left on the joystick drives the pedestal East and West.
Rotate
With the Rotate switch to the left, push the joystick left/right to rotate the pedes-
tal in place.
Raising/Lowering The Column
Twist the joystick knob to raise or lower the column. Do not raise or lower the
column until it has been pressurized and balanced - see Chapter 3.
2-10
L O C
R E M
R O T A T E
Operation
User Manual
Advertisement
Table of Contents
