Table of Contents
Advertisement
SP-2000/X-Y
4.
Plug the MCB controller cable into the Power/Data MCB connector on the
pedestal. Set the Local/Remote switch on the MCB to Remote.
5.
Press and hold the Standby/Charge (yellow) button on the pedestal until the
light comes on and stays on. If the batteries are discharged (typically below
24V on the control panel voltmeter) and the pedestal will not turn on, refer
to AC Powered Unloading below.
6.
Press the Run (green) button on the pedestal and the light will come on and
the pedestal circuits will initialize. Wait about 30 seconds until all three
wheels have initialized (the North wheel is first, followed by the West
wheel then the East wheel) before moving on to the next step.
User Manual
WARNING: The MCB controller MUST always be in
Remote when you turn on the SP-2000/X-Y pedestal.
L O C
R E M
R O T A T E
Installation
3-7
Advertisement
Table of Contents
