1St Speed Command Or Limit; 2Nd Speed Command Or Limit; 3Rd Speed Command Or Limit - Delta Electronics ASDA-B Series User Manual

Chapter 7 Servo Parameters|ASDA-B Series
P1 - 09 SPD1

1st Speed Command or Limit

Default: 100
Applicable Control Mode: S/T
Unit: rpm
Range: -5000 ~ +5000
Settings:
1st Speed Command
In Speed mode, this parameter is used to set speed 1 of internal speed command.
1st Speed Limit
In Torque mode, this parameter is used to set speed limit 1 of internal speed command.
P1 - 10 SPD2

2nd Speed Command or Limit

Default: 200
Applicable Control Mode: S/T
Unit: rpm
Range: -5000 ~ +5000
Settings:
2nd Speed Command
In Speed mode, this parameter is used to set speed 2 of internal speed command.
2nd Speed Limit
In Torque mode, this parameter is used to set speed limit 2 of internal speed command.
P1 - 11 SPD3

3rd Speed Command or Limit

Default: 300
Applicable Control Mode: S/T
Unit: rpm
Range: -5000 ~ +5000
Settings:
3rd Speed Command
In Speed mode, this parameter is used to set speed 3 of internal speed command.
3rd Speed Limit
In Torque mode, this parameter is used to set speed limit 3 of internal speed command.
7-28
Communication Addr.: 0109H
Related Section:
S mode: Section 6.3.5
T mode: P1-02
Communication Addr.: 010AH
Related Section:
S mode: Section 6.3.5
T mode: P1-02
Communication Addr.: 010BH
Related Section:
S mode: Section 6.3.5
T mode: P1-02
Revision January, 2009