Do Force Output Diagnosis Operation - Delta Electronics ASDA-B Series User Manual

Chapter 4 Display and Operation|ASDA-B Series

4.1.6 DO Force Output Diagnosis Operation

For testing, the digital outputs can be forced to be activated (ON) or inactivated (OFF) by using
parameter P4-06. Follow the setting method in Figure 4.10 to enter into DO force output diagnosis
operation (OP x) mode ("x" indicates the parameter range from 0 to 7). Pressing UP or DOWN arrow
key can change "x" value from 0 to 7 (hexadecimal format) and force digital outputs DO1 to DO3 to be
activated (ON) or inactivated (OFF). The DO function and status is determined by P2-18 to P2-20. This
function is enabled only when Servo Off (the servo drive is disabled).
Figure 4.10
4-14
Force DO1 to be activated
Force DO2 to be activated
Force DO3 to be activated
:
P 4 - 0 6 F O T
0
SET
P 4 - 0 6 : F O T
O P 0
P 4 - :
0 6 F O T
O P
1
P 4 - :
0 6 F O T
O P 2
Revision January 2009