Save Mode - Delta Electronics ASDA-B Series User Manual

SAVE Mode (

1. When the power is applied to the AC servo drive, the digital keypad will enter into the monitor
mode first.
2. In monitor mode, pressing FUNC key first. Then, pressing UP key four times or DOWN key
three times can switch to SAVE mode.
3. In SAVE mode, pressing UP and DOWN key can save the desired memory block that the users
want to save.
4. If the desired memory block has not been used, the LED display will show the message "00000"
or "10000" or "20000" or "30000", etc. If the desired memory block has been used and there are
parameters data saved in it, the LED display will show the MCU version of the servo drive and
the preset file name. For example, if the MCU version is 1.014, the message "01014" or "11014"
or "21014" or "31014", etc. will show on the LED display. The users can change the save
address (memory block) by using UP and DOWN keys.
5. After the save address (memory block) is selected, press FUNC key, the LED display will show
. At this time, pressing MODE key once can return to the previous display, pressing
FUNC key can record the address and save the data. When recording the address, the LED
display will show
show "0XXXX" (such as "01012" shown in Figure 4.10 on next page).
6. In SAVE mode, pressing MODE key once can return to the previous display and finally exit the
SAVE mode. However, if the users have pressed the FUNC key and enter into SAVE mode, i.e.
the SAVE operation has been executed, the MODE key will become disabled, and the users
cannot return to previous display and only can move to the next step.
7. The users can save the parameters in some memory block repeatedly on the condition that the
version, inertia and models of the servo drives should be the same. If one of the parameters is
set by the servo drive in different condition, it cannot be saved into the same memory block with
other parameters and must be saved to other memory blocks. Before re-using the same
memory block, please perform the "Memory Block Clear" function first (Please see the
description of parameter P8-11).
Revision January 2009
Chapter 4 Display and Operation|ASDA-B Series
Save parameter settings from the Drive to the Keypad)
. After the address is saved to the keypad, the LED display will
4-21