Lcd Backlight Display; Memory Block Clear - Delta Electronics ASDA-B Series User Manual

2: LED testing.
3: Dynamical memory testing (RAM). The testing time is approx. 18 seconds.
4: Data memory testing (EEPROM). The testing time is approx. 140 seconds.
This parameter is used to test the hardware of the keypad. Since the life of the data memory is
limited and using this parameter will consumed the life of data memory, it is not recommended to
use this parameter and change the factory default setting if not necessary.
P8 - 10 KBLT

LCD Backlight Display

Default: 0
Applicable Control Mode: P/S/T
Unit: N/A
Range: 0 ~ 1
Settings:
0: OFF. LCD backlight is going off.
1: ON. LCD backlight is going on.
P8 - 11 KCLR

Memory Block Clear

Default: 0
Applicable Control Mode: P/S/T
Unit: N/A
Range: 0 ~ 124
Settings:
ASD-PU-01A
ASD-PU-01B
Revision January, 2009
Chapter 7 Servo Parameters|ASDA-B Series
Communication Addr.: 080AH
Related Section: N/A
Communication Addr.: 080BH
Related Section: N/A
7-71