Highway Assist System - Jeep COMPASS Owner's Handbook Manual

The system activation is signalled by the
green symbol and a message on the
instrument panel display.
NOTE The "Cruise Control" (where
provided) and "Adaptive Cruise Control
(ACC)" functions (where provided) will
not be available while the Intelligent
Speed Assist is in use.
Speed limit setting
The detection of a new speed limit is
notified by a message on the instrument
panel display. You can decide whether
to accept or reject the proposal to adjust
the limiter by pressing the SET+, SET-
buttons located on the steering wheel
fig. 231.
Hold the SET + button pressed to
increase the speed in 5 km/h or 5 mph
steps.
Hold the SET - button pressed to
decrease the speed in 5 km/h or 5 mph
steps.
Exceeding the speed limit
If the speed limit determined by reading
the road signs or by traffic conditions is
exceeded, the symbol
a warning message will appear on the
instrument panel.
Deactivation
To deactivate the device, press the
button fig. 231. A message will
appear in the instrument panel display
to confirm that the function has been
turned off.
228
You can also disable the Speed Limiter
by pressing the CANC button. In this
case, the system is not completely
disengaged and you can re-activate the
Intelligent Speed Assist by pressing the
RES button.

HIGHWAY ASSIST SYSTEM

(where provided)
The Highway Assist system combines the
functions of the Active Cruise Control
(ACC) device and lane centring logic to
control the trajectory of the car holding it
as close as possible in the middle of the
lane and also managing speed.
294) 295) 296) 297) 298) 299) 300) 301)
It is a driving assistance system that can
be activated on motorways with separate
carriageways.
The system uses information from the
front camera to help you keep the car
in the middle of the lane at a constant
speed.
OPERATION
The system only works if the driver keeps
will flash and
his or her hands on the steering wheel.
If the system detects that hands have
been removed from the steering wheel,
it will alert you of the need to put your
hands back on the steering wheel (see
following pages).
WARNING The Highway Assist system
can take a few seconds to activate once
all conditions are met. During this time,
a grey indication will appear on the
instrument panel display and the system
will be activated automatically as soon
as all conditions are met, without any
intervention by the driver.
1
232
The following conditions must be met
before the Highway Assist system turns
on:
the Highway Assist system must be
switched on by pressing the button (1)
fig. 232 on the steering wheel;
the Adaptive Cruise Control device
(ACC) must be on;
the car speed must be between 60
and 150 km/h;
no anomaly related to the camera must
be present;
the direction indicators must not be
activated;
no anomaly related to the system must
be present;
if the set speed is less than 60 km/h
the Highway Assist system will not work;
5520695D