Jeep COMPASS Owner's Handbook Manual page 302

Data" section) or the pressure
indicated on the specific label, stop the
compressor by pressing the ON-OFF
button again;
disconnect the cartridge (A) fig. 316
from the compressor, by pressing the
release button (H) and lifting the
cartridge upwards.
315
A
H
316
If the pressure gauge (G) fig. 315
indicates a pressure lower than 1.8 bar
(26 psi) 15 minutes after starting the
compressor, switch off the compressor,
disconnect the sealing fluid tube D from
300
the tyre valve and remove the cartridge
(A) from the compressor.
Move the car by approximately 10
metres to allow the distribution of
the sealant. Stop the vehicle safely,
operate the electric parking brake
and restore pressure using the black
inflation pipe (L) fig. 317 to reach the
required pressure. If also in this case,
the pressure is lower than 1.8 bar / 26
psi 15 minutes after turning on, do
not resume driving but contact a Jeep
Dealership. After driving for about 8 km /
5 miles fig. 318, move the car to a safe
and suitable area and engage the electric
parking brake. Take the compressor and
restore pressure using the black inflation
tube (L).
J0A0957
317
J0A0958
318
If the pressure shown is higher than
1.8 bar / 26 psi, restore the pressure
and drive safely to a Jeep Dealership
as soon as possible. If, however, the
pressure is lower than 1.8 bar / 26 psi,
do not resume driving but contact a Jeep
Dealership.
PROCEDURE FOR RESTORING
THE PRESSURE
Proceed as follows:
stop the car safely, as described
above, and operate the electric parking
brake;
extract the black inflation tube and
screw it firmly onto the tyre valve. Then
L
follow the instructions below. Press the
air release button to adjust any excessive
J0A0959
tyre pressure (see "Repair procedure"
paragraph).
CARTRIDGE REPLACEMENT
Proceed as follows:
only use original cartridges, which can
be purchased from the Jeep Dealership;
8 km / 5 mi
J0A0960