Charging Procedure From Wallbox Charging Station ("Smart" Wallbox) - Jeep COMPASS Owner's Handbook Manual

IMPORTANT
98) You do not need to wait until
the high-voltage battery level is low
to recharge. The performance of the
high-voltage battery is optimal when it is
charged regularly.
99) Charging the high-voltage battery may
take longer if the temperature of the high-
voltage battery is high or low.
100) During charging, especially with fast
charging, high-voltage battery cooling
components may be voltage activated.
Therefore, it is normal to hear noises
during this operation.
101) Do not charge if the external
temperature is -30 ° C or lower, as charging
is likely to take longer and the charging
device may be damaged.
102) Do not leave the car or the charging
cable in areas where the external
temperature is below -40 ° C as they may
be damaged.
103) In cold temperatures, the charging
cable may become stiff. Therefore, be
careful not to apply excessive force to the
charging cable as it may be damaged.
104) Do not use personal generators to
charge the high-voltage battery. This may
cause fluctuations in charging and the
voltage may be insufficient, resulting in
damage to the car system.
105) Charging the high-voltage battery
using incorrect or damaged sockets, or
charging cables and not following the
prescribed charging procedures may
cause short circuits, fire and potential risk
of damage to the electrical system of the
car.
250
CHARGING PROCEDURE
FROM WALLBOX
CHARGING STATION
("SMART" WALLBOX)
(Plug-in Hybrid version)
WARNING The "smart" wallbox domestic
charging station must be installed by
qualified personnel after checking
the domestic electrical system. For
information on available "smart" wallbox
charging stations, contact a Jeep
Dealership.
The high-voltage battery of the car can
be charged by directly connecting the
charging cable on the "smart" wallbox
charging station or using the "Mode 3"
cable (optional).
For the characteristics of the "Mode 3"
cable, refer to the "Power sources that
can be used - Mode 3 cable" chapter.
Charging with "smart" wallbox
charging station allows to reach, from a
domestic user, a higher charge power
than the charge achieved using a
domestic socket: the charging time, as a
consequence, is significantly reduced.
Some "smart" wallbox charging stations
can be programmed from the mobile
app.
WARNING If programming is present
both on the "small" wallbox charging
station and on the car (Uconnect™" or
mobile app), the charging system gives
priority to programming of the wallbox
(excluding the programming of the car).
NOTE The "smart" wallbox charging
station configuration may vary depending
on the country where the car is sold.
NOTE The electrical system of the house
must be checked regularly by qualified
personnel.
The maximum charging current value
is automatically set by the device,
depending on the building's electrical
system.
For the charging procedure, refer to the
"Charging from domestic power supply
(AC) socket procedure".
CHARGING PROCEDURE
FROM PUBLIC CHARGING
STATION (AC)
(Plug-in Hybrid version)
344) 345) 346)
106) 99) 108)
The high-voltage battery of the car can
be charged by directly connecting the
charging cable of the public charging
stations or using the "Mode 3" cable
(optional).
For the characteristics of the "Mode 3"
cable, refer to the "Power sources that
can be used - Mode 3 cable" chapter.
To charge, proceed as follows: