Jeep COMPASS Owner's Handbook Manual page 242

CHARGE STATUS CONTROL
UNIT
332) 333)
Signal LED
There are three LEDs on the front of the
charge status control unit:
GREEN LED on (1) fig. 246: indicates
correct operation in the domestic power
distribution system: it is therefore
possible to proceed with the high-voltage
battery charging.
RED LED on (2): indicates a fault in the
charging system.
YELLOW LED on (3): indicates a
possible failure in the domestic power
distribution system.
WARNING Never carry out any repair
work on your own: always contact the
Jeep Dealership.
240
246
For the type of failure, refer to the
description under "Charging system
failure" on the following pages.
Symbol label
On the back of the charging status
control unit there is a summary label,
fig. 247, which shows some symbols.
The main ones are listed below:
This symbol indicates a risk
of electric shock.
this symbol indicates a
general dangerous situation.
This symbol shows
the minimum operating
temperature of the charge
status control unit in
accordance with IEC
61851 and IEC 62752
certification.
NOTE FCA guarantees
that the device has been
tested for use from -40°C
to +50°C. If the device
is not used and must be
stored, the temperature
must be between -40°C and
+80°C. Exceeding these
temperature values may
damage the device.
The presence of this symbol
on the label indicates that
the specific "Mode 2"
charge cable cannot be
5520750D
used for domestic power
distribution networks where
the earthing cable is not
present. For specific
markets, without the
earthing cable, check for
"COUNTRY GROUP" on the
label of the charging cable.
the presence of this symbol
on the label indicates that
the charging status control
unit does not have the
function of disconnecting
the earthing cable.