Power Sources That Can Be Used - Jeep COMPASS Owner's Handbook Manual

Hide thumbs Also See for COMPASS:
Table of Contents

Advertisement

Power sources for electric
charging. Identification
of vehicle compatibility.
Graphic symbol for consumer
information in accordance with
EN17186:2019.
The symbols shown below make it easier
to recognise the correct power source type
to use when charging your car.
Before charging, check the symbol
(where provided) inside the charging port
flap and compare it with the symbol on
the charging cable (where provided).
Symbols for electrically powered vehicles:
Symbol on the cable charging connector
(car side) for Mode 2 and Mode 3 cables
and on the charging port flap
238
AC (alternating current) charging in the
home or at a charging station (≤ 480 V
RMS).
Symbol on the cable charging connector
(charging station side) for the Mode 3
cable and on the charging station
234
Before charging, check the symbol
(where provided) on the charging cable
and compare it with the symbol on the
charging cable (where provided).
239
AC (alternating current) charging at a
charging station (≤ 480 V RMS).
WARNING
303) The charging current level ("Level
1" / "Level 2" / "Level 3", etc.) can only
be changed via the Uconnect™ system
display (see the "Uconnect™" chapter in
the "Multimedia" section). The default
charge level set is "Level 3". For countries
in which the 13A "Mode 2" charge cable
can be used, if the domestic power socket
IS NOT CERTIFIED, it is recommended
F1A0717
to set "Level 4" charge to the maximum,
which corresponds to approx. 10A. For
the list of country-specific cable types
refer to what is indicated in the "Mode 2
cable variant table".
304) In order to reduce the risk of electric
shock or damage to the device, special
care should be taken when cleaning:
ALWAYS unplug the device from the
domestic power supply socket and car
ports.
IMPORTANT
97) Avoid leaving the high-voltage battery
for several days with the charge indicator
at or near zero. The high-voltage battery
may be damaged.
POWER SOURCES THAT
CAN BE USED
(Plug-In Hybrid versions)
F1A0725
305) 306) 307) 308) 309) 310) 311) 312) 313) 314) 315)
316) 317) 318) 319) 320) 321) 322) 323) 324) 325) 326) 327)
328) 329) 330) 331)
GENERAL INFORMATION
The high-voltage battery of the car can
be charged not only through the heat
engine operation , but also using special
charging cables that allow:
the connection of the charging port
located on the rear left side of the car
to the charging ports in public charging
stations;
or
to the domestic socket.
Regular and complete charging of
the high-voltage battery reduces fuel
consumption by using electrical energy
thanks to the operation of the electric
motor.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents