Jeep COMPASS Owner's Handbook Manual page 32

Entry key fob to Memory" paragraph in
this chapter.
Linking the Remote Keyless Entry key fob to
Memory
Your remote keyless entry key fob can
be programmed to recall one of two pre-
programmed memory profiles with a
push of the button on the key fob.
NOTE Before programming your key fob
you must select the "Memory Liked To
FOB" function through the Uconnect™
system screen. Refer to the "Settings"
paragraph in the "Multimedia" section
for further information.
To program your key fob, perform the
following:
1. Take the ignition device to STOP.
2. Select the desired memory profile (1)
o (2).
NOTE If a memory profile has not
already been set, refer to "Programming
the Memory feature" in this section for
instructions on how to set a memory
profile.
3. Press and release the memory button
(S) on the memory switch, then within
five seconds press the button marked
with (1) or (2) and release it. The
instrument panel display shows "Memory
profile set". (1) o (2).
4. Push and release the
key fob within 10 seconds.
30
NOTE The key can be excluded from the
memory settings by first pressing the
button (S) and then the button
key within 10 seconds.
Memory position recall
NOTE the automatic transmission
must be in the P (Park) position to
recall memory positions. If a recall is
attempted when the vehicle is not in P
(Park), a message will appear in the
instrument panel display.
To recall the memory settings for
driver one, push memory button (1) or
the button on the key fob linked to
memory position 1.
To recall the memory settings for
driver two, push memory button (2) or
the button on the key fob linked to
memory position 2.
A recall can be cancelled by pushing
any of the memory buttons (S, 1, or
2) during a recall. When a recall is
cancelled, the driver seat will stop
moving. A delay of one second will occur
before another recall can be selected.
Front heated seats
(where provided)
The front heated seats control buttons
are located within the Uconnect™
system. You can gain access to the
control buttons through the climate
button on the
screen or the controls screen.
Push the switch
setting on (High level).
on the Press the button
turn the LO setting on (Low level).
Press the button
turn the function to OFF (Heating off).
If the car is provided with automatic
temperature controls with integrated
centre column or manual temperature
controls, the switches
on the switch assembly below the
Uconnect™ system display.
When the HI (High Level) level setting
is selected, the system automatically
switches to LO (Low Level) after about
60 minutes of continuous operation. At
this point, the display changes from HI
to LO to indicate the change. The LO
level function will turn off automatically
after about 45 minutes.
IMPORTANT In order to preserve the
conventional battery, this feature cannot
be activated when the engine is off.
Vehicles with remote start
(where provided)
On models equipped with the remote
start function, heated seats can be
programmed so that they are activated
during remote start.
This function can be programmed
via the Uconnect™ system. Refer
to the "Settings" paragraph in the
"Multimedia" section for further
information.
39) 40)
once to turn the HI
a second time to
a third time to
are located