Jeep COMPASS Owner's Handbook Manual page 226

220
Press the fig. 220 button twice until
the LED lights up to deactivate the
LaneSense system. A dedicated message
will appears on the instrument panel
display (where provided).
Push the button once again (LED turns
on) to turn the LaneSense system off.
NOTE The choices made by the driver
using the Uconnect™ system screen
during LaneSense customisation, such
as the intensity of the torque/vibration
on the steering wheel, the sensitivity of
the warning zone, the speed of reaction,
will also be maintained the next time the
engine is started. Refer to the "Settings"
paragraph in the "Multimedia" section
for further information.
SYMBOLS AND MESSAGES ON
THE DISPLAY
System on
When the system is active and the lane
limits have not been detected, the
224
lane line appear grey. See fig. 221 (7"
display) or fig. 222 (10" display).
5520653D
221
222
NOTE If only one limit is detected, only
the corresponding lane line will be
coloured green, yellow or red, leaving the
other in grey.
Lane limit detection
When the system is active and lane
limits have been detected, the lane
limits are coloured green (fig. 223,
fig. 224).
223
5520789D
224
Approaching the lane
When the system detects that the
5520790D
car has approached the lane line
and is about to cross it, the line on
corresponding side will appear yellow
on the corresponding side ( fig. 225,
fig. 226).
5520791D
5520792D