Table of Contents
Advertisement
The vehicle is close to the obstacle when the warning display shows one flashing arc and sounds a continuous tone. The following chart shows the warning alert operation when
the system is detecting an obstacle:
Greater than
Rear Distance
79 inches
(inches/cm)
(200 cm)
Arcs — Left
None
Arcs — Center
None
Arcs — Right
None
Audible Alert
None
Chime
Radio Volume
No
Reduced
NOTE:
ParkSense will reduce the volume of the radio, if on,
when the system is sounding an audio tone.
ENABLING AND DISABLING
PARKSENSE
ParkSense can be enabled and disabled
with the ParkSense switch located below the
Uconnect display.
When the ParkSense switch is pushed to
disable the system, the instrument cluster display
page 124 will show the "ParkSense Off" message
for approximately five seconds. When the gear selector
is moved to REVERSE and the system is disabled, the
instrument cluster display will show the "ParkSense
Off" message for as long as the vehicle is in REVERSE
(Not in 4WD Low).
WARNING ALERTS
79-59 inches
59-47 inches
(200-150 cm)
(150-120 cm)
None
None
6th Solid
5th Solid
None
None
Single 1/2
Slow
Second Tone
(for rear center only)
(for rear center only)
Yes
Yes
The ParkSense switch LED will be on when ParkSense
is disabled or requires service. The ParkSense switch
LED will be off when the system is enabled. If the
ParkSense switch is pushed, and requires service, the
ParkSense switch LED will blink momentarily, and then
the LED will remain on.
SERVICE THE PARKSENSE REAR
PARK ASSIST SYSTEM
During vehicle start up, when the ParkSense Rear Park
Assist System has detected a faulted condition, the
instrument cluster display will actuate a single chime,
once per ignition cycle, and it will display the
"ParkSense Unavailable Wiper Rear Sensors" or the
"ParkSense Unavailable Service Required" message.
47-39 inches
39-25 inches
(120-100 cm)
(100-65 cm)
None
None
4th Solid
3rd Flashing
None
None
Slow
Fast
(for rear center
(for rear center
only)
only)
Yes
Yes
When the gear selector is moved to REVERSE and the
system has detected a faulted condition, the instru-
ment cluster display will show the "ParkSense Unavail-
able Wiper Rear Sensors" or "ParkSense Unavailable
Service Required" message for as long as the vehicle is
in REVERSE. Under this condition, ParkSense will not
operate.
If "ParkSense Unavailable Wiper Rear Sensors"
appears in the instrument cluster display, make sure
the outer surface and the underside of the rear fascia/
bumper is clean and clear of snow, ice, mud, dirt or
other obstructions and then cycle the ignition. If the
message continues to appear, see an authorized
dealer.
If "ParkSense Unavailable Service Required" appears in
the instrument cluster display, see an authorized
dealer.
STARTING AND OPERATING
181
Less than
25-12 inches
12 inches
(65-30 cm)
(30 cm)
2nd Flashing
1st Flashing
2nd Flashing
1st Flashing
2nd Flashing
1st Flashing
Fast
Continuous
Yes
Yes
4
Advertisement
Table of Contents
