Jeep COMPASS Owner's Handbook Manual page 210

Rear distance: 100-65 cm
Left arch: off
Middle arch: 3rd arc on fixed
Right arch: off
Acoustic signal: no
Uconnect™ volume down: yes
Rear distance: 65-30 cm
Left arc: 2nd arc flashing
Middle arch: 2nd arc flashing
Right arc: 2nd arc flashing
Acoustic warning: The acoustic
warning increases as objects become
closer to the car
Uconnect™ volume down: yes
Rear distance: greater than 30 cm
Left arc: 1st arc flashing
Middle arch: 1st arc flashing
Right arc: 1st arc flashing
Acoustic warning: continual
Uconnect™ volume down: yes
Front Park Assist audible alerts
ParkSense will turn off the Front Park
Assist audible alert (chime) after
approximately three seconds when an
obstacle has been detected, the car is
stationary, and brake pedal is applied. If
the obstacle has been detected within
less than 30 cm, then the Parksense will
not turn off the Front Park Assist audible
alert.
Adjustable acoustic warning volume
settings
The volume of the acoustic warning for
the parking assist system in forward
or reverse gear can be adjusted in
208
the section related to functions that
can be programmed by the user of
the Uconnect™ system. Refer to the
"Settings" paragraph"Multimedia"
section.
If the car is equipped with Uconnect™
system, the acoustic warning volume
settings will not be accessible from the
instrument panel display.
The acoustic warning volume can be
set to "low", "medium", and "high".
The factory default volume setting is
medium.
ParkSense will retain its last known
configuration state through ignition
cycles.
Enabling and Disabling
ParkSense
The ParkSense system can be turned on
or off by pressing the button
on the panel below the Uconnect ™
system display fig. 187.
187
When the button is pushed to disable
the system, the instrument panel will
display the dedicated message for
approximately five seconds. For more
information, refer to the "Display"
chapter in the "Knowing the instrument
panel" section. When the ParkSense
switch is in R (Reverse) position and the
system is off, the ParkSense off alert
message appears on the instrument
panel display for the entire time the car
is in R (Reverse).
The LED of the
when ParkSense system is disabled
or requires service. The LED switches
off when the system is active. If the
switch is pushed, and requires service,
the ParkSense switch LED will blink
momentarily, and then the LED will be
ON.
ParkSense park assist system
When the ParkSense system detects a
located
fault when starting the car, an audible
warning sound is emitted, at each
ignition cycle, and the message
"ParkSense unavailable, clean rear
sensors", "ParkSense unavailable,
clean front sensors" or "ParkSense
unavailable, service required" is shown
on the instrument panel display for five
seconds. The system will continue to
provide visual warnings in the form of an
arc on the side is working properly. The
car symbol remains displayed with a gear
engaged as long as the speed remains
5520817D
below 11 km/h. When the transmission
is in reverse gear, the car symbol is
button will be ON