Jeep COMPASS Owner's Handbook Manual page 248

CHARGING SYSTEM/
MAINTENANCE/CLEANING
The device is maintenance-free.
If you need to clean the device, use a
soft cloth slightly dampened with a mild
detergent solution, then wipe dry with a
dry cloth. Do not use abrasive products
or flammable substances (e.g. alcohol,
petrol or their derivatives). Do not wash
the device with water, hazard of fire or
electric shock with the risk of serious
injury or death.
WARNING Only clean the device when
it is DISCONNECTED from both the
domestic charging port and the charging
port located on the car.
FCC (Federal Communications
Commission) SPECIFICATIONS
The state of charge Control Unit
complies with Section 15 of the FCC
Regulation.
The use of the device meets the
following two requirements:
1. This device does not cause harmful
interference.
2. The correct operation of the device
may be affected by interference from
nearby electrical/electronic devices.
This device is designed to withstand
radio frequency interference (RFI),
however, some factors (e.g., high
intensity radio signals or radio
transmitters in the vicinity of the device)
may cause it to malfunction. If you
246
find an anomaly in the operation of the
device, contact the Jeep Dealership.
WARNING Modifications and/or repairs
made incorrectly and NOT carried out by
the Jeep Dealership will invalidate the
Warranty and the above requirements.
"MODE 3" CHARGING CABLE
(optional)
The car can be equipped with a "Mode 3"
charging cable fig. 248, located inside a
special bag fig. 249, placed in the boot.
The "Mode 3" charging cable:
complies with EN 61851- 1, EN
62196- 1 and EN 62196- 2 standards
can be used for a minimum
temperature of -40°C up to a maximum
temperature of +50°C
This type of cable allows you to connect
to public alternating current (AC)
charging stations. The charging speed
may be faster than charging through a
domestic power socket.
Using this type of cable it is possible to
charge the car with a current of up to
32A.
NOTE After use, remember to replace
the protective covers on both sides of
the charging cable correctly to prevent
moisture and/or dust from entering the
cable charging port connections.
248
249
Charging system/maintenance/cleaning
The device is maintenance-free.
If you need to clean the device, use a
soft cloth slightly dampened with a mild
detergent solution, then wipe dry with a
dry cloth. Do not use abrasive products
or flammable substances (e.g. alcohol,
petrol or their derivatives). Do not wash
the device with water, hazard of fire or
electric shock with the risk of serious
injury or death.
WARNING Only clean the cable when it
is DISCONNECTED from both the public
J0B6140E
J0B6080E