Head Restraints - Jeep COMPASS Owner's Handbook Manual

heater. The heat could cause burns even
at a low temperature, especially when
used for long periods of time.
40) Do not place objects on the seat or on
the backrest that may isolate the heat,
such as a cover or a pillow. This may
cause the seat heating device to overheat.
Sitting on an overheated seat may cause
severe burns due to the increase in
temperature of the seat surface.
41) If a passenger is present, it won't
be possible to use the armrest, but the
central backrest needs to be properly
attached.
42) Make sure the backrest is locked
perfectly. Otherwise, the seat would not
provide the necessary stability for child
and/or passenger seats. An improperly
secured seat could cause serious injury.
IMPORTANT
6) The fabric upholstery of the seats has
been designed to withstand long-term
wear deriving from normal use of the car.
Some precautions are however required.
Avoid prolonged and/or excessive rubbing
against clothing accessories such as
metal buckles and Velcro strips which, by
applying a high pressure on the fabric
in a small area, could cause it to break,
thereby damaging the upholstery.
7) Before tilting the backrest, remove any
objects on the seat cushion.
8) Do not arrange objects beneath the
electrically adjustable seat and do not
impede its movement, since the controls
may be damaged. They may also restrict
the seat travel.
32

HEAD RESTRAINTS

43) 44) 45)
FRONT HEAD RESTRAINTS
(adjustments)
Upward adjustment: raise the head
restraint until it clicks into place.
Downward adjustment: press button (1)
fig. 27 and lower the head restraint.
Where the function is present, the head
restraints can be adjusted forwards and
backwards. To adjust the head restraint
forwards, pull the top of the head
restraint towards the front of the car to
the desired position and release it. To
adjust the head restraint backwards, pull
the top of the head restraint forwards
to the maximum position and release.
The head restraint must go back to the
furthermore position.
27
43) 46)
REAR HEAD RESTRAINTS
(adjustments)
Upward adjustment: raise the head
restraint until it clicks into place.
Downward adjustment: press button (1)
fig. 28 and lower the head restraint.
28
IMPORTANT If the rear seats are used,
always set the head restraint of the
central position in the "completely
extracted" position.
47)
HEAD RESTRAINTS (removal)
Proceed as follows to remove the head
restraints:
raise the head restraints to their
maximum height;
press button (1) fig. 27 (front
head restraints) or fig. 28 (rear
head restraints) at the side of the
5520839D
two supports, then remove the head
restraints by pulling them upwards.
WARNING Always re-position the rear
head restraints if they had been removed
5520840D