Jeep COMPASS Owner's Handbook Manual page 287

Replacing exterior bulbs
NOTE It is advisable to contact a Jeep
Dealership.
LED main beam/dipped beam headlights
Contact a Jeep Dealership for
replacement.
Direction indicators
1. Steer the wheel completely inwards.
2. Remove the screws (1) fig. 286 of the
wheel arch.
3. Rotate the bulb holder (2) fig. 287
anticlockwise and extract it.
286
2
287
4. Extract the bulb and replace it.
5. Refit the connector and turn the bulb
holder clockwise.
6. Reinstall the wheel arch liner.
Fixed rear light cluster
(Tail lights/Brake lights/Rear direction
indicator)
1. Open the liftgate.
2. Tip the protection caps (1) fig. 288
and undo the screws.
288
3. Pull out the headlight cluster sliding it
towards the rear of the car.
5520253D
4. Disconnect the electrical connector by
pushing the release.
5. Turn the connector of the bulb to be
replaced a quarter turn anticlockwise.
6. Extract the bulb and replace it.
7. Refit the connector and turn it
clockwise.
8. Reconnect the electrical connector
and reinsert the lamp assembly into the
body, taking care to insert the spherical
pins into their seats.
5520726D
9. Tighten the fixing screw and replace
the protection caps.
Rear fog light
1. Using a suitable non-marking tool,
carefully pry at the bottom inboard edge
of the fog light (fig. 289) to disengage
the snap elements.
289
2. Remove the bulb holder (1) fig. 290
by turning it anticlockwise and remove it
from the light.
5520359D
290
3. Pull the bulb to remove it from the
bulb holder.
5520370D
5520371D
285