Section 5 - Accelerator And Brake Pedal Group; Pedal Group - Electric Vehicle; Pedal Group Removal - Club Car Onward 2018 Maintenance And Service Manual

SECTION 5 — ACCELERATOR AND BRAKE PEDAL GROUP
DANGER
Accelerator and Brake Pedal Group
• See General Warnings on page 1-2.
WARNING
• See General Warnings on page 1-2.
PEDAL GROUP – ELECTRIC VEHICLE
See General Warnings on page 1-2.

PEDAL GROUP REMOVAL

1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
2. Remove screws (1). Pull floor mat retainer (3) away from the vehicle (Figure 5-1, Page 5-1).
3. Pull floor mat (2) over the pedal group to gain access to the pedal group hardware.
Figure 5-1 Pedal Group Access
4. Remove fastener (10) and lift off cover plate (7) (Figure 5-2, Page 5-2).
5. Loosen jam nuts (4 and 5) on each side of turnbuckle (6).
NOTE: Nut (4) has a left-hand thread.
6. Loosen turnbuckle (6) until the threaded rod (8) from the pedal group (11) is free of the turnbuckle (Figure 5-2,
Page 5-2).
7. Remove two screws (2) on the driver side of the pedal group and two screws (1) on the passenger side of
the pedal group.
8. Disconnect the wire harness (12) from the MCOR (13).
9. Lift pedal group from vehicle.
2018 Onward Maintenance and Service Manual
5
Page 5-1