Parts Required - Heartland VALUE Series Assembly Manual

FLOOR FRAME
3" (7,6 cm) x40
5
Put both floor sections together and attach as shown using 3" nails.
FINISH
6
You have finished your floor frame. Proceed to level and square frame.
(4) Nails per side,
stagger pattern.
116-5/8"
(296 cm)
Flush
LEVEL AND SQUARE FLOOR FRAME
Before attaching floor decking, it is important to level and square the floor frame.
A level and square floor frame is required to correctly construct your shed.
BEGIN
1
See page 8 for the preferred floor leveling method.
2
Use level and check the frame is level before applying floor panels.
Check for frame squareness by measuring diagonally across corners. If the measurements are the
3
same, the frame is square. The diagonal measurement will be approximately 167-3/8" (425 cm).
4
When the frame is level and square secure one side of frame to the 4x4 runners using one fastener
at ends of each runner. At the opposite end of the frame, secure the frame to 4x4 runners with one
fastener at ends of each runner making sure the frame remains square (Fig. A).
FINISH
Once the floor frame is level and square fasten the frame at each point the frame contacts the 4x4
5
runners.
First, secure at ends with
one fastener.
120"
(305 cm)
Second, secure at ends
with one fastener.
167-3/8"
(425 cm)
167-3/8"
(425 cm)
Fig. A
12
FLOOR PANELS (NOT INCLUDED)

PARTS REQUIRED:

Floor Panels not included
x1
See page 3 for panel sizes
3/4 x 48 x 92-5/8"
(1,9 x 122 x 235 cm)
Ensure your fl oor frame is square by installing one panel and squaring frame.
BEGIN
Attach the 3/4 x 48 x 92-5/8" panel with the rough side up (painted-grid lines
1
side) with the 48" edge and corner fl ush to the fl oor frame (Fig A). Secure
panel with two 2" nails in the cor ners.
Move to the opposite end. Using the long edge of the panel as a lever move the
2
panel side-to-side until the top cor ner is fl ush to the fl oor frame (Fig. B).
Secure panel with two 2" nails in the corners.
Check the fl oor frame is squar e by measuring diagonally across the frame cor ners. If the measur ements are
3
the same your fl oor frame is square. The measurement will be approximately 167-3/8" (425 cm) (Fig. C).
4 Continue attaching the panel using 2" nails 6" apart on edges and 12" apart inside panel.
Use a chalk line or use pr e-painted grid lines to nail into joists under panel.
1-1/2"
(3,8 cm)
3/4"
(1,9 cm)
Approximately
Grid lines UP
Flush
120"
(305 cm)
2" (5 cm) x55
and quantities.
6" (15 cm) edges of panel.
Flush
92-5/8"
(235 cm)
12" (30,5 cm) inside panel.
48"
(122 cm) 167-3/8"
(425 cm)
13
13
Fig. A
Flush
(2) Nails
(2) Nails
Flush
at top
corner
edge.
Fig. B
167-3/8"
(425 cm)
Fig. C