Parts Required; Rafter Assembly - Heartland HILLSDALE GABLE Manual

PARTS REQUIRED:

x2
AL 2 x 4 x 7" (5,1 x 10,2 x 17,8 cm)
It is very important to assemble your rafters using the following method for an even and flat roof.
¸
BEGIN
1
Secure (1) AL flush to the floor deck with (2) 3" screws.
Measure over 120-3/4" and install a second GPC flush to the floor deck. AL will overhang floor.
Secure with (2) 3" screws.
144"
(365,8 cm)
(2) 3" (7,6 cm)
Screws
Flush
FINISH
You have finished building the main roof rafter jig. Proceed to assemble your rafters.

RAFTER ASSEMBLY

(304,8 cm)
AL x2
120-3/4"
IMPORTANT MEASUREMENT !!
(306,7 cm)
x6
120"
Floor Width
12
3" (7,6 cm)
There will be an
overhang on
this end.
3/4"
(1,9 cm)
Flush