Heartland VALUE Series Assembly Manual page 22

PARTS REQUIRED:
Rafter
Assemblies
x4
BEGIN
Arrange four rafters centered on the mark you made for locating the wall
1
studs. (Fig. A). The rafters also line up directly over the wall studs.
Check you have the measurements shown.
Attach with two 3" screws at each end (Fig. A).
FINISH
You have finished installing your rafters.
2
NOTE: Measurements from inside of panels
22-1/4" 24"
(56,5 cm) (61 cm)
Maintain the measurements between rafters.
RAFTERS
3" (7,6 cm) x16
24" 24" 22-1/4"
(61 cm) (61 cm) (56,5 cm)
Align over studs.
Screw
Fig. A
Center on mark
for wall stud.
38
PARTS REQUIRED:
x2
SU
2 x 4 x 59-3/4" (5 x 10 x 152 cm)
BEGIN
1 Install SU at same height as top plates and level. Install using two 3" nails at
each connection, as shown.
1/4"
(6 mm)
Angle
Flush
LOFT JOISTS
BACK WALL
SU
CENTER
3"
(7,6 cm)
SAME HEIGHT
39
1/4"
(6 mm)