Heartland VALUE Series Assembly Manual page 18

SIDE WALL FRAMES
PARTS REQUIRED:
x4
NH
2" x 3" x 46-1/4" (5 x 7,6 x 117 cm)
x8
OU
2" x 3" x 68-3/4 " (5 x 7,6 x 174,6 cm)
x4
OZ
2" x 3" x 70-1/4" (5 x 7,6 x 178 cm)
BEGIN
Orient parts on edge on floor. Measure and mark from end of boards. Make
1
marks 1-1/2" long. They will be used later (FIG. A).
IMPORTANT! You will build two walls the same.
2 Use two 3" nails at each mark.
3
You have finished building one side wall frame. Proceed to attach wall panels.
46-1/4"
(117,5 cm)
Stagger
Seams
1-1/2"
(3,8 cm)
NH
Toenailing
OU x4
OZ
1-1/2"
(3,8 cm)
Stagger
Seams
70-1/4"
(178,5 cm)
3" (7,6 cm) x20
94-1/4"
(244,5 cm)
70-1/4"
(178,5 cm)
46-1/4"
(117,5 cm)
22-1/4"
(57 cm)
OZ
Center on marks.
1-1/2"
(3,8 cm)
NH
46-1/4"
(117,5 cm)
30
PARTS REQUIRED:
x2
Ensure your wall frame is square by installing one panel and squaring frame.
Place the 48 x 72" panel onto wall frame with primed side up as shown. Note the lip
4
and square edges.
Use the gauge block to mark the 3/4" measurement on the wall stud. Locate the panel
5/8" down on the top plate. Secure panel with two 2" nails in the corners (Fig. A).
Move to the opposite end. Using the long edge of the panel as a lever move the panel
5
side-to-side until you have a 3/4" measurement on the wall stud. Secure corner with
two 2" nails.
6
Nail the panel using 2" nails 6" apart on edges and 12" apart inside panel.
For squareness maintain 3/4" and
5/8" measurement along panel edge.
Make mark
1-1/2"
long.
Fig. A
HINT:
SIDE WALL PANELS
3/4"
GAUGE BLOCK
3/8 x 48 x 72"
(1 x 122 x 183 cm)
BEGIN HERE
5/8"
(1,6 cm)
3/4"
(1,9 cm)
3/4" Gauge Block
6" (15 cm)
12" (30 cm)
LIP
EDGE
48"
3/4"
(122 cm)
(1,9 cm)
There will be an overhang at
31
2" (5 cm) x34
Do not nail
in groove.
2 Nails
5/8"
(1,6 cm)
3/4"
(1,9 cm)
Fig. A
3/4"
(1,9 cm)
Fig. B
2 Nails
SQUARE
EDGE
top and bottom.