Heartland VALUE Series Assembly Manual page 14

BACK GABLE PANELS AND TRIM
PARTS REQUIRED:
x4 PD
2 x 3 x 45-1/8" (5 x 7,6 x 115 cm)
x1
Check panels
LEFT
SQUARE
have these
EDGE
Edge painted
edges.
green and black.
1 You will be attaching trim PD from the backside of the gable panels (Fig. A).
You will assemble a RIGHT and a LEFT assembly.
2 Place trim PD on floor. Orient red ends as shown.
3 Place a left or right gable panel onto trim primed side down
(Fig.A). Verify the square and lip edges.
4
Locate trim PD flush to edges and secure with six 1-1/4" screws 11" apart.
FINISH
You have finished building the back gable panel assemblies.
5
Continue building your backwall.
RED END of PD
Flush
PD
Look for edge
painted red
Primed side is down.
and black.
Use a 2x3
on flat for
support.
x1
RIGHT
LIP
EDGE
Edge painted
red and black.
PRIMED SIDE
DOWN.
IMPORTANT!
Fig. A
Flush
11" (28 cm)
PD
Approximately
Look for edges
painted green
and black.
22
PARTS REQUIRED:
x1
1-1/4" (3 cm) x24
CO
x1
Pre-assembled
Center CO on edge onto wall frame and
1
secure using two 3" screws (Fig. A).
2 Place the left gable panel onto wall frame
primed side up and onto CO.
Make sure edge of panel lines up with right
edge of groove (Fig B).
Nail with 2" nails 6" apart.
Place right gable panel onto wall frame primed side
3
up and onto CO and flush to left gable panel.
Nail with 2" nails 6" apart.
FINISH
You have finished building your backwall.
4
Carefully flip the back wall off the floor.
BACK WALL GABLE PANELS
2 x 3 x 25" (5 x 7,6 x 63,5 cm)
LEFT RIGHT x1
Pre-assembled
1-1/2"
(3,8 cm)
48-3/4"
(124 cm)
Flush
6" (15 cm)
23
2" (5 cm) x24
3" (7,6 cm) x2
CO
CO
48-3/4"
(124 cm) Screws 3"
(7,6 cm)
Flush
Fig. A
LEFT
Fig. B
Line up panel
with right edge
of groove
3/8"
Edge of
0,9 cm
groove.
Flush
RIGHT
Flush
6"
(15 cm)