Heartland VALUE Series Assembly Manual page 21

PARTS REQUIRED:
x4 PF
2 x 3 x 41" (5 x 7,6 x 104 cm)
1
Install front lower gable trim PF so two points contact PD and
corner trim OB as shown.
2 Secure PF to wall using six 1-1/4" screws 7-1/2" apart. Screw through
panels into PF (Fig A).
3
Repeat above steps to secure the back wall lower gable trim.
FINISH
You have finished installing your lower gable trim.
4
Two points contact
PD
each other.
PF
OB
GABLE TRIM
Panel
Fig. A
PD
PF
7-1/2" (19 cm)
Approximately
36
PARTS REQUIRED:
1-1/4" (3 cm) x24
x8
RAFTER-HALF
BEGIN
You will build FOUR assemblies;
1
Place two rafter-halves in the corner of back and side walls. The
RED ENDS identify the ends to be connected at the center.
1-1/4"
(3,2 cm)
Screw
2 Apply glue to rafters where the gusset will fit.
RED ENDS of Rafters must touch together at the peak. Nail gusset to rafters using twelve 2"
PF 3
nails in pattern shown.
4
Flip over rafter assembly and repeat STEPS 2-3 to attach second gusset to other side.
5 Repeat STEPS 1-4 to build THREE additional rafter assemblies.
FINISH
6 You have finished assembling
your rafters.
OB
RAFTERS
Pre-assembled
GUSSET
x8
120"
(305 cm)
Fit base of rafters in corners
of back wall.
Temporary support (OO
)
RED ENDS TOGETHER
x2
GUSSET
Center
Glue
Glue
37
2" (5 cm) x96
HINT:
Use floor and walls to help
assemble rafters!
RED ENDS TOGETHER
1/4" gap (6 mm)
2" (5 cm)