Door Hardware - Heartland VALUE Series Assembly Manual

DOOR WEATHERSTRIP
PARTS REQUIRED:
x2
OO
2 x 3 x 69" (5 x 7,6 x 175 cm)
BEGIN
With left door closed, center a weatherstrip OO vertically on the left door in
1
the door opening (Fig. A). OO will offset the left door 1" OUT past the door
trim 1" (Fig. B).
Secure OO using seven 3" screws through outside trim into OO (Fig. B)
2
On right door center OO vertically in door opening (Fig. A). OO will offset the
3
right door 1" IN from the door trim (Fig. C).
Secure OO using seven 3" screws through outside trim into OO (Fig. C).
4
FINISH
You have finished installing your door weatherstrips.
5
Center OO
in door
opening.
Fig. A
2" (5 cm) x14
1" OFFSET
(2,5 cm)
OO
OFFSET
1"
(2,5 cm)
Fig. B Fig. C
50
PARTS REQUIRED:
BEGIN
1 Mount barrel bolt flush at top of OO on left door using 3/4" screws as shown (Fig A).
2 With door closed mark hole location for bolt to extend into.
HINT: Extend bolt to leave a mark in wood. Tap bolt with hammer. Drill 3/8" hole
deep enough for bolt to slide into.
Install hasp on right door and latch on left door. Bottom edge of hasp is
3
35-1/2" (90 cm) up from bottom edge of door trim. Measure and mark locations and
install with 3/4" screws as shown (Fig B).
FINISH
4
You have finished mounting your door hardware.
Screws
2"
(5 cm)
Screws
2"
(5 cm)
x14

DOOR HARDWARE

x1 x1
3/4" (1,9 cm) x4 3/4" (1,9 cm) x7
Fig. A
LEFT
DOOR
35-1/2"
(90 cm)
51
3/8" (9 mm) Drill Bit
Drill 3/8" hole
in-line with bolt.
Flush on OO.
OO
HINT: With door closed extend bolt and
tap with hammer to leave a mark in wood
for drilling.
3/4" (1,9 cm) Screw x7
Install on right door.