Heartland VALUE Series Assembly Manual page 32

SHINGLES - RIDGE CAP
• You will finish off the top of the roof with a ridge cap made from shingles.
BEGIN
1
Cut shingles into THREE pieces. Hint: Use cut-off pieces first.
2"
(5 cm)
2" 2"
(5 cm) (5 cm) (5 cm)
Weather Seal
2
Install first ridge cap flush to shingles at front, as shown.
Flush
3
Install second ridge cap 5" back, as shown.
5"
12,7 cm
FRONT OF
SHED
2"
(5 cm
2" 2"
(5 cm)
Score shingle,
then snap-off angled cut.
Top of slot.
24 to 26
Note: • You will need about 24 - 26 cut pieces.
Pieces
(1) Nail per side through weather seal.
FRONT OF
SHED
(1) Nail per side through weather seal.
Flush
58
SHINGLES - RIDGE CAP
4
Continue installing ridge cap to back of roof.
5
Make sure there is 4" between the shingle-color and edge of shingles.
6
When you have 4" minimum of shingle color cut one piece to cap your roof.
7 Install flush to shingles.
FINISH
8 You have fi nished your ridge cap.
continued...
4"
(10 cm)
Trim cap off flush to shingles
Cut at top of rain slot.
Cap
Flush to shingles
(2) Nails per side.
59